Wavetronix VDR24 Radar Manual de usuario descargar pdf (Pagina 66)

Support, Maintenance, Troubleshooting

66 VDR24 Radar Detection System, Rev 1.0

9.1.7. Verify Runtime Metrics

9.1.7.1. Total Run Time

During continuous operation the system processor keeps track of accumulated run time in

Years, Days, and Hours. This value may be viewed by navigating to screen 4.1. The system is

expected to run uninterrupted and any power failure or internal protective reset will restart the

run time counters. If the run time counter does not accumulate as expected between

maintenance visits, and there have not been known internal or external site power interruptions,

then the cause for those interruptions should be investigated and discovered. It is

recommended that System Runtime metrics be checked on monthly intervals.

9.1.7.2. Watchdog Timer Resets

If any internal conditions arise that suggest any of the VDR24 Controller processors are not

operating correctly, the system will initiate a reset procedure, called a Watchdog Timer Reset.

This is tantamount to the system re-starting itself. Because this is a metric that pertains to

internal self-checks, the number of watchdog timer resets (called WD Resets) is provided on the

front panel display in Screen 3.2.

These reset procedures are not representative of normal operation and any occurrences

whatsoever should be discussed with Island Radar engineering and support.

System'Processor'Census''''''''''4.1'''

'Firmware'V1.00.96''01/31/20914'

'Resets'''0003'WD'''0008'Powerup'

'Radar1'''Not'Connected'

'Radar2'''Not'Connected'

'Runtime''00Years'002Days'21Hours'

(

)

Health'and'System'Messages'''''''3.2'''

'Radar'1''''''''''''''SelfCheckFail'

'Radar'2''''''''''''''SelfCheckFail'

'Processor1'''''''00WD''''14Powerup'

'Processor2'''''''00WD''''14Powerup'

'SystemProcessor''00WD''''14Powerup'

''''''''''''''''''''

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 77 78

Sin comentarios

Wavetronix VDR24 Radar Manual de usuario Pagina 66