Wavetronix Command DataView (CMD-DV) - User Guide Manual de usuario descargar pdf (Pagina 56)

CHAPTER 5  WORKBOOKS PAGE 55

 Start/End Date – Allows you to select start and end dates for publishing data. Default

is the start and end date for the entire workbook. Neither date can exceed the natural

start/end date for the workbook.

 Station List – Allows you to select one or more stations from the stations available in

the workbook. Select each station to publish using the checkbox at le. e Groups

menu can be used to lter stations based on their station group assignments.

Figure 5.13 – Publish Subset of Workbook Data

Click Publish when the settings are complete. If successful, the browser will report back

that the data was published successfully.

Note

If data for a given station and time interval already exists in the published data

source when another publish operation is requested AND the new data diers from

the old data in one or more values, the data must be merged. In this case, the Merge

Data page will open and request more information about how to merge the old and

new data together. See the section below on merging data.

Merging Data

In cases where new data records are being published to an already existing published data

source with the same station ID and timestamp, you must decide whether to keep the old

data or overwrite it with the new data. e Merge Data page appears whenever you try to

publish data with conicts between old and new data with dierent values (see Figure 5.14).

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 105 106

Sin comentarios

Wavetronix Command DataView (CMD-DV) - User Guide Manual de usuario Pagina 56