Wavetronix SMARTSENSOR 105 Guía de usuario descargar pdf (Pagina 18)

CHAPTER 1  INSTALLING THE SMARTSENSOR MATRIX 17

45°

Edge of ﬁrst lane of interest

Stop Bar

Pan sensor

towards stop bar

Figure 1.3 – Corner Radar Field of View Position

To visualize the extent of the sensor eld of view, the 90° eld of view is imprinted on the

top and bottom of the sensor case. If more of a visual indicator is needed, then a square

framing tool (e.g. rafter square) or other tool with a right angle can be held above the

sensor. By looking down both edges of the tool, you can visualize the extent of the radar’s

coverage.

Usually the front edge of the sensor’s eld of view is aligned to provide coverage beyond

the stop bar (see Figure 1.4). is allows you to place detection zones beyond the stop bar

to detect those vehicles that do not stop at or behind the stop line and will also allow the

sensor to see vehicles exiting queues. If the sensor pole is upstream from the stop bar, it is

recommended to pan in the direction of the stop bar.

Front edge of ﬁeld of view

Figure 1.4 – Sensor Aligned by Rotating Towards the Stop Bar

Use the following steps to correctly align the SmartSensor Matrix:

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 106 107

Sin comentarios

Wavetronix SMARTSENSOR 105 Guía de usuario Pagina 18