Wavetronix Click 342 (lean managed ethernet switch) (CLK-342) Manual de usuario Pagina 59

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 76
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 58
58 CHAPTER 6 RAPID SPANNING TREE
e switch with the lowest numerical switch ID becomes the root. It is recommended
that the root port and alternate port are specied using the priority.
Port Identifier – e port ID consists of 4 bits for the port priority and 12 bits for the
port number. e port ID is interpreted as an unsigned integer value. When comparing
two port IDs, the one with the lowest numeric value is of higher priority.
Figure 6.5 – RSTP Port Configuration Web Page
e RSTP Port Conguration page contains the following elds (see Figure 6.5):
Port Number – Indicates the number of the port currently selected.
Port Name – Indicates the name of the port.
RSTP Port State – Indicates the status in which this port takes part in STP.
Operational Edge Port – Indicates whether this port is operated as an edge port.
Admin Edge Port – Here you can specify whether this port is to be operated as an edge
port (default setting), if possible.
Priority – Indicates the priority set for this port. Due to backwards compatibility with
STP, priority values can be set that are not congurable in RSTP.
Admin Path Cost – Indicates the path costs set for this port. A path cost equal to “0”
activates the cost calculation according to the transmission speed (10 MBps = 100; 100
MBps = 19).
Path Cost – Indicates the path costs used for this port.
Forward Transitions – Indicates how oen the port switches from the “Discarding
state to the “Forwarding” state. Additional parameters provide information about net-
work paths in a stable topology that are used by the BPDU telegrams.
Designated Root – Gives the root bridge for this Spanning Tree.
Designated Bridge – Indicates the switch from which the port receives the best BPDUs.
e value is based on the priority value in hex and the MAC address.
Designated Port – Gives the port from which the BPDUs are sent. e value is based
on the port priority (2 digits) and the port number.
Vista de pagina 58
1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 75 76

Comentarios a estos manuales

Sin comentarios