Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manual de usuario descargar pdf (Pagina 96)

CHAPTER 8  VERIFY CHANNELS-ALERTS-ZONES 95

Note

In Figure 8.5 the dashed, gray line near the top of the zone is used to indicate the

location of the discovery range threshold for this priority channel. Vehicles ﬁrst dis-

covered before the discovery range threshold will be highlighted when viewing at the

Level 1 alert and will also have a priority level of one when shown on the roadway.

Vehicles ﬁrst discovered after the discovery range threshold will be highlighted when

viewing at the Level 2 alert and will also have a priority level of two when shown on

the roadway.

Simple channels (annotated with an S) show only the channel output in the right-side bar,

and priority channels (annotated with a P) go one layer deeper to the alert level. Because a

priority channel only has one zone for each alert, only the alert level is shown. e normal

channel (annotated with an N) and latched channel (L) go further down to the zone level

(see Figure 8.6).

Figure 8.6 – Individual Channel View (Normal Channel)

A zone output is activated when its detection qualication lters are satised; an alert out-

put is activated when the associated zone outputs fulll the alert’s logic lter; and a channel

output is activated when the associated alert outputs (and related delay and extend settings)

fulll the channel’s requirements.

Note

Only channel outputs are reported to contact closure devices. While they are reported

to SSMA, zone and alert outputs are not directly associated with any contact closure

outputs.

e channel name is displayed above the channel LED. Latched channels display an L next

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 147 148

Sin comentarios

Wavetronix SmartSensor Advance Extended Range (SS-200E) - Use Manual de usuario Pagina 96