Wavetronix Command Collector (CMD-DCx) - User Guide Manual de usuario descargar pdf (Pagina 62)

CHAPTER 5  SENSOR CONFIGURATION PAGE 61

Figure 5.11 – Sensor Command Tab

e following is a list of basic commands:

 Update Conﬁguration – Attempts to download the current sensor conguration from

the sensor. Although Collector will automatically update the sensor conguration on a

timed interval, a manual update conguration command can be sent at any time.

 Sync Sensor Time – Attempts to set the onboard sensor time equal to the current

server time. Collector will automatically synchronize the sensor time on a timed inter-

val, although a manual sync time command can be sent at any time.

 Set Sensor Interval – Attempts to set the sensor interval to the given value in seconds.

Acceptable sensor intervals depend on the individual sensor rmware; consult the sen-

sor documentation for any limitations on sensor intervals. Changing the sensor inter-

val in this tab does not aect the collection interval that Collector uses to communicate

with the sensor; the collection interval must be changed separately.

Collector also supports any number of custom commands that a particular sensor brand

(and driver) supports. Any additional commands supported by the driver will be listed in

the Custom Command section.

Follow the steps below to run a custom command:

1 Select the Custom Command radio button.

2 Select the command name from the Name drop-down menu.

3 If necessary, ll in any additional parameters required by the command in the Proper-

ties table.

4 Click the Run Command button.

Note

After clicking the Run Command button, a loading image will appear until the result

is displayed or the timeout is reached. It is possible for the timeout to hit before the

command completes successfully.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 116 117

Sin comentarios

Wavetronix Command Collector (CMD-DCx) - User Guide Manual de usuario Pagina 62