Wavetronix Command Translator (CMD-DT) - User Guide Manual de usuario descargar pdf (Pagina 52)

CHAPTER 4  ROUTES PAGE 51

closest to an asset location are the most relevant; however users are free to map any seg-

ments to any asset within the route. Segments can be mapped to more than one asset. It is

recommended (but not required) that all segments have a mapping to at least one asset to

avoid gaps in the travel time processing.

Recalibrating Segments

Aer assets have been added to the route, segments can be congured to match the loca-

tions of those assets automatically through the use of the Recalibrate Segments button,

located in the Options panel.

Note

Using the Recalibrate Segments function will remove any previous segment deﬁ-

nitions and segment mappings created by the user—the entire route will be recon-

structed according to current assets.

Recalibration will generally create one segment per existing asset, with the segment bound-

aries dened by the asset type: point assets will create a segment with the asset located in

the exact middle of the segment. Other asset types will typically use that asset location as a

segment boundary, with separate segments on the le and right sides of the asset location.

e exact length of segments dened by an asset will vary based on the quantity and loca-

tion of other assets in the route—more assets will result in smaller segments, as the system

tries to divide up the length of the route fairly.

Aer recalibration has nished, you’ll be free to add/modify/delete segments, making ad-

justments as needed.

Note

If additional assets are added to a route that was previously recalibrated, segments

will not be automatically generated to match the new assets. Users will need to

manually conﬁgure segments to match those assets, or run the recalibration pro-

cess again with the new assets included (which will invalidate any previous manual

changes to segments from the earlier recalibration).

Travel Points

Travel points are start and end points for specic travel time calculations, in cases where

trip times between locations other than the start and end boundaries for the route are de-

sired. To manage travel points, select the Travel Point tab (see Figure 4.18).

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 155 156

Sin comentarios

Wavetronix Command Translator (CMD-DT) - User Guide Manual de usuario Pagina 52