Wavetronix Command Translator (CMD-DT) - User Guide Manual de usuario descargar pdf (Pagina 88)

CHAPTER 8  BASIC TASKBUILDER FUNCTIONS 87

 Creating multiple actions from the same start component to dierent end components.

e same start component information will be used for each action.

Figure 8.6 – Multiple Actions from the Same Start Component to Dierent End Components

 Creating actions from multiple start components to the same end component. In cer-

tain situations, such as the end component being a le and the File Operation property

being set to Overwrite, this will not be optimal because the results of later actions will

eliminate the results of the rst action.

Figure 8.7 – Actions from Multiple Start Components to the Same End Component

Below is an action that is NOT allowed in TaskBuilder:

 Creating actions that form a loop; tasks must be directed acyclic graphs. If adding an

action creates a circle where you can trace through any number of actions and com-

ponents back to the start component, the action is illegal. All task trees must be nite.

To avoid loops, create a copy of the original start component to act as the new end

component.

Example

If A-to-B is an action and B-to-C is an action, C-to-A is an illegal action because it

would form a loop. To avoid this loop, make a copy of A, in this case named D, to

act as a separate component in the abstract task design. The ﬂow of the task then

becomes A-to-B-to-C-to-D.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 155 156

Sin comentarios

Wavetronix Command Translator (CMD-DT) - User Guide Manual de usuario Pagina 88