Wavetronix SmartSensor HD (101-0415) - User Guide Manual de usuario descargar pdf (Pagina 15)

14 CHAPTER 1  INSTALLING THE SMARTSENSOR HD

Attaching the Mount Bracket to the Pole

Before attaching the mount bracket to the pole, rst make sure that your cables are long

enough to reach the sensor and to stretch across the distance from the sensor to the cabinet.

Follow the steps below to correctly attach the mount to the pole (see Figure 1.2):

1 Insert the stainless steel straps through the slots in the mount bracket.

2 Position the mount bracket on the pole so that the head of the mount is pointing to-

wards the middle of the lanes of interest.

3 Tighten the strap screws.

Note

The sensor will need to be adjusted later, to ﬁne-tune the alignment, so be sure to

keep the straps adjustable.

Figure 1.2 – Attaching the Mount Bracket to the Pole

Attaching the Sensor to the Mount Bracket

Use the following steps to securely fasten the sensor to the mount bracket:

1 Align the bolts on the sensor’s backplate with the holes in the mount bracket. e con-

nector at the bottom of the unit should be pointing towards the ground.

2 Place the lock washers onto the bolts aer the bolts are in the mount bracket holes.

3 read on the nuts and tighten (see Figure 1.3).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 88 89

Sin comentarios

Wavetronix SmartSensor HD (101-0415) - User Guide Manual de usuario Pagina 15