Wavetronix SmartSensor HD (101-0415) - User Guide Manual de usuario descargar pdf (Pagina 26)

CHAPTER 2  CONNECTING POWER AND SURGE 25

Note

An authorized electrical technician should perform installation and operation of this

unit. Persons other than authorized and approved electrical technicians should NOT

attempt to connect this unit to a power supply and/or trac control cabinet, as there

is a serious risk of electrical shock through unsafe handling of the power source. Ex-

treme caution should be used when connecting this unit to an active power supply.

Wiring in AC

e rst step is to get AC power into the enclosure. (Sometimes the power source is actually

DC; to see Wavetronix’s selection of DC power modules, see the Click 100–400 Series User

Guide.) If you’re using a main trac cabinet, wire from its power source; if you’re using a

pole-mount box, the power lines or cable can be brought in through the conduit on the

bottom-le.

Note

Make sure power to AC mains is disconnected while wiring AC input.

Wiring the Click 210

e rst device in the power plant, as seen in Figure 2.5, is the Click 210. is is a compact

circuit breaker DIN rail device designed to interrupt an electric current under overload

conditions. e breaker is trip-free and can be easily reset aer a current interruption by

pushing the reset button.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 88 89

Sin comentarios

Wavetronix SmartSensor HD (101-0415) - User Guide Manual de usuario Pagina 26