Wavetronix SmartSensor HD (101-0415) - User Guide Manual de usuario descargar pdf (Pagina 51)

50 CHAPTER 5  SETTINGS

Figure 5.3 – Outputs Tab

 Source – Allows you to determine what information is reported. ere are two options:

Antenna reports data as detected by the antenna in the sensor, and Diagnotic creates

detection events for testing and training purposes.

Note

If the sensor is in Diagnostic or Replay mode, it will not detect live trac.

 RF Channel – Displays which radio frequency channel the sensor is transmitting on.

Using multiple sensors in close proximity will require each sensor to be set to a dier-

ent RF channel (see the introduction for more information about mounting sensors in

close proximity).

 Loop Emulation – is section allows you to set loop size and spacing to allow Smart-

Sensor HD to emulate dual loops. e settings changed on this screen will apply to all

congured lanes. ese settings are read by a Click contact closure device and used so

that the contact closures can be properly timed to emulate a given loop size and spac-

ing. e loop size is also used by the sensor in the occupancy calculation. For example,

larger loop sizes will result in higher occupancy numbers in the interval data. However,

adjusting these parameters will not modify the reported vehicle length or speed (see

Chapter 6 of this user guide to accomplish these tasks).

 Legacy Protocols – e SS105 protocol must be selected when being used with Click

communication and contact closure devices (it is not necessary if you are only using

Click surge and power devices). is does not turn o native SSHD protocol.

e RTMS (X3): ID checkbox allows you to turn RTMS protocol emulation on or o;

only a subset of RTMS data reporting commands are emulated. is does not turn o

native SSHD protocol. e RTMS ID eld will only be editable if the RTMS Protocol

checkbox is selected.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 88 89

Sin comentarios

Wavetronix SmartSensor HD (101-0415) - User Guide Manual de usuario Pagina 51