Wavetronix SmartSensor HD (101-0415) - User Guide Manual de usuario descargar pdf (Pagina 30)

CHAPTER 2  CONNECTING POWER AND SURGE 29

To put power on the T-bus, you will rst need to connect a 5-screw terminal block to the

end of the T-bus, then follow the steps below to wire DC to it:

1 Connect +DC (red) from the Click 201/202 to the top screw terminal on the 5-screw

terminal block.

2 Connect –DC (black) to the second screw terminal.

+24V DC

-DC

(red wire)

(black wire)

Green

Gray

+485

-485

GND

Figure 2.8 – Connecting Power Directly to the T-bus

Note

Green T-bus connectors conduct power and communication on the DIN rail backplate;

gray T-bus connectors only conduct power and are used to distribute power without

connecting communication.

You can also wire DC to the Click 200 itself; it will then put that power on the T-bus. If you’d

like to do that, follow these steps:

1 Connect +DC (red) from the Click 201/202 to the +DC screw terminal.

2 Connect -DC (black) to a GND screw terminal.

GND

+DC

Figure 2.9 – Wiring DC Power into the Click 200

Wiring Communication

e last thing to do is decide how to communicate with the sensor. How you do this will

vary based on your installation. If your sensor is connected to a Click 200 in a pole-mount

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 88 89

Sin comentarios

Wavetronix SmartSensor HD (101-0415) - User Guide Manual de usuario Pagina 30