Wavetronix SmartSensor 105 (SS-105) - User Guide Manual de usuario descargar pdf (Pagina 52)

CHAPTER 5  SENSOR SETTINGS 51

Figure 5.2 – General Tab

 Serial Number – Shows the 16-digit serial number given to the sensor by the manu-

facturer, used to uniquely identify the sensor. is is the only setting on this screen that

cannot be edited.

 SmartSensor (Multidrop) ID – Allows you to enter a 4-character ID number. is

number is used to identify the sensor on a multi-drop network. Each sensor on such

a network must have a unique ID number. is number is referred to on the Sensor

Information page as the sensor ID.

 RTMS ID – Lets you change the RTMS ID. e SmartSensor has been designed to

utilize other protocols for those cases when there might already be a project built

around another type of sensor. If you choose to communicate using the RTMS proto-

col, all you need is the RTMS ID.

Note

The RTMS ID number 13 cannot be used for polled communications.

 Description – Allows you to create a description of the sensor and/or installation site

for identication purposes. e description may be up to 32 characters long and will

be displayed on the Sensor Information page.

 Location – Allows you to enter the location of the sensor for identication purposes.

e location may be up to 32 characters long and will be displayed on the Sensor In-

formation page.

 Orientation – Lets you select, from a drop-down menu, the direction the sensor is

facing. e orientation does not aect sensor operation or alignment and is simply for

your information.

 Measurement Units – Allows you to choose between English and metric measure-

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 98 99

Sin comentarios

Wavetronix SmartSensor 105 (SS-105) - User Guide Manual de usuario Pagina 52