Wavetronix SmartSensor 105 (SS-105) - User Guide Manual de usuario descargar pdf (Pagina 69)

68 CHAPTER 6  LANE SETUP

Note

If the connection’s additional response wait time is greater than 500 ms, event and

actuation information is not displayed on the screen.

Trac (Event) Data

In Event mode, this screen allows you to verify the SmartSensor’s conguration by compar-

ing the trac on the road to event information shown in the window (see Figure 6.8). In

order to keep a record of your verication results, the event data can also be saved to a log

le while you remain on this screen.

Figure 6.8 – View Trac (Event) Data

e window can also be used to verify true presence information by switching to Actuation

mode (click the A icon).

Note

A status bar below the Trac View window indicates whether you are in Event mode

or Actuation mode.

By default, Trac View launches in Event mode. In Event mode, the vehicles (represented

by the blue rectangles) appear after having passed through the radar detection zone.

e four icons located at the bottom of the screen are active in this mode. ey are, from

left to right:

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 98 99

Sin comentarios

Wavetronix SmartSensor 105 (SS-105) - User Guide Manual de usuario Pagina 69