Wavetronix SmartSensor 105 (SS-105) - User Guide Manual de usuario descargar pdf (Pagina 63)

62 CHAPTER 6  LANE SETUP

However, the detection thresholds congured for the sensor during the automatic congu-

ration process are based upon the current level of the gain and will continue to adapt for up

to one minute after clicking the Finished button.

Note

The default starting point of 5 is also the largest starting point allowed. If you enter

a value larger than 5 the default starting point of 5 will be used. If you are managing

the gain, you should generally change the starting point to a 3 or 4.

Lane Conﬁguration – Manual

If the sensor is unable to automatically congure itself to your satisfaction, you can manu-

ally congure it by adding, removing or adjusting lanes, lane dividers and lane centers.

To make changes in Manual mode:

1 With the Lane Conguration page open, select the Manual button; the buttons in

the toolbar on the right of the screen will change from gray to black (see Figure 6.2).

Figure 6.2 – Manual Lane Conﬁguration

2 Selecting a button in the toolbar will allow you to make changes using the roadview

window on the left.

3 Once you’ve made the necessary adjustments, hit Finished to save your changes.

Adjust Lanes

e Adjust Lanes button allows you to click your cursor on any visible shoulder (gray line),

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 98 99

Sin comentarios

Wavetronix SmartSensor 105 (SS-105) - User Guide Manual de usuario Pagina 63